メインコンテンツにスキップ

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての8個のガイドに反映されます。

英語
中国語

手順 24を翻訳中

手順24
As you complete the next few steps, prying adhesive securing the logic board in place, always start by testing gently to see if the adhesive is softened. If not, reheat the iOpener and reapply it to the back of the rear case. Carefully insert an opening pick under the logic board, between the front-facing camera and the battery. Slide the pick toward the front-facing camera connector, and stop at the bend in the logic board.
  • As you complete the next few steps, prying adhesive securing the logic board in place, always start by testing gently to see if the adhesive is softened. If not, reheat the iOpener and reapply it to the back of the rear case.

  • Carefully insert an opening pick under the logic board, between the front-facing camera and the battery.

  • Slide the pick toward the front-facing camera connector, and stop at the bend in the logic board.

当你完成之后几个步骤的时候,撬开固定的黏胶。如果不行,重新加热 iOpener 放到后盖后面。

仔细地在主板下插入一个开机撬片,前置摄像头和电池之间。

向前置摄像头接口那边滑动撬片,停在主板弯曲的地方。

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります