メインコンテンツにスキップ

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての8個のガイドに反映されます。

英語
イタリア語

手順 24を翻訳中

手順24
As you complete the next few steps, prying adhesive securing the logic board in place, always start by testing gently to see if the adhesive is softened. If not, reheat the iOpener and reapply it to the back of the rear case. Carefully insert an opening pick under the logic board, between the front-facing camera and the battery. Slide the pick toward the front-facing camera connector, and stop at the bend in the logic board.
  • As you complete the next few steps, prying adhesive securing the logic board in place, always start by testing gently to see if the adhesive is softened. If not, reheat the iOpener and reapply it to the back of the rear case.

  • Carefully insert an opening pick under the logic board, between the front-facing camera and the battery.

  • Slide the pick toward the front-facing camera connector, and stop at the bend in the logic board.

Man mano che completi i prossimi passi, esercitando un'azione di leva sull'adesivo che fissa la scheda logica in posizione, comincia sempre provando delicatamente per verificare che l'adesivo si sia ammorbidito. Se non è così, riscalda di nuovo l'iOpener e riposizionalo sulla parte posteriore del case.

Inserisci delicatamente un plettro di apertura sotto la scheda logica, tra la fotocamera frontale e la batteria.

Fai scorrere il plettro verso il connettore della fotocamera frontale e fermati sulla piega della scheda logica.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります