メインコンテンツにスキップ

注意:あなたはさきほど閲覧していたガイドの前提条件を編集しています。あなたが行った変更は、この手順を含む個のガイド全体に影響を与えます。

英語
日本語

手順 5を翻訳中

手順5
Tilt the display backwards. Grip the display from its base to reduce torque. Use a spudger to pry the upper part of the back panel by pushing in the tabs located along its length. This step is particularly tricky during reassembly, as the plastic must be perfectly aligned or it will not snap in. If it does not snap in correctly, the screen won't fit properly.
  • Tilt the display backwards. Grip the display from its base to reduce torque.

  • Use a spudger to pry the upper part of the back panel by pushing in the tabs located along its length.

  • This step is particularly tricky during reassembly, as the plastic must be perfectly aligned or it will not snap in. If it does not snap in correctly, the screen won't fit properly.

  • Carefully lift the display free of the case.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります