メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

注意:あなたはさきほど閲覧しているガイドの前提となるページを編集しています。あなたが行った変更は、この手順を含むガイド全体に影響を与えます。

英語
日本語

手順 1を翻訳中

手順1
If your I/O Board cable's connectors have notches in the padding, you will need to release a locking lever underneath the notch in order to remove the cable. If this is the case, don't pry up on the connector until the levers are unlatched. Using the flat end of a spudger, pry the I/O Board connector straight up out of its socket on the logic board. During reassembly, connect this end first as it does not flex.
  • If your I/O Board cable's connectors have notches in the padding, you will need to release a locking lever underneath the notch in order to remove the cable. If this is the case, don't pry up on the connector until the levers are unlatched.

  • Using the flat end of a spudger, pry the I/O Board connector straight up out of its socket on the logic board.

  • During reassembly, connect this end first as it does not flex.

  • In a similar fashion, remove the I/O Board connector from its socket on the I/O Board.

  • Remove the I/O Board cable from the MacBook Pro.

スパッジャーの平面側先端を使って、I/O ボードコネクターを基板上のソケットから真っ直ぐ引き上げます。再組み立ての際は、このコネクターの先端を先に接続してください。

同じ方法で、I/OボードコネクタをI/Oボード上のソケットから接続を外します。

MacBook ProからI/Oボードケーブルを外します。

[* icon_note] If your I/O Board cable's connectors have [link|https://guide-images.cdn.ifixit.com/igi/NcprwYqAITaNGRVg.full|notches in the padding], you will need to '''release a locking lever underneath the notch''' in order to remove the cable. If this is the case, '''don't pry up on the connector until the levers are unlatched'''.
[*
black] Using the flat end of a spudger, pry the I/O Board connector straight up out of its socket on the logic board. On
[* icon_reminder] During
reassembly, connect this end first as it does not flex.
[* icon_note] If your I/O Board cable's connectors have [link|https://guide-images.cdn.ifixit.com/igi/NcprwYqAITaNGRVg.full|notches in the padding], you will need to '''release a locking lever underneath the notch''' in order to remove the cable. If this is the case, '''don't pry up on the connector until the levers are unlatched'''.
[*
black] Using the flat end of a spudger, pry the I/O Board connector straight up out of its socket on the logic board. On
[* icon_reminder] During
reassembly, connect this end first as it does not flex.
[* black] In a similar fashion, remove the I/O Board connector from its socket on the I/O Board.
[* black] Remove the I/O Board cable from the MacBook Pro.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります