メインコンテンツにスキップ
英語
日本語

手順 3を翻訳中

手順3
Remove printed circuit board, LED, battery, and motor assembly from the screwdriver casing. Use a soldering iron to melt the solder from the LED's two pins on the printed circuit board. Remove the LED from the circuit board while the solder is still melted.
  • Remove printed circuit board, LED, battery, and motor assembly from the screwdriver casing.

  • Use a soldering iron to melt the solder from the LED's two pins on the printed circuit board.

  • Remove the LED from the circuit board while the solder is still melted.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります