メインコンテンツにスキップ
英語
日本語

手順 4を翻訳中

手順4
Ensure that the front panel is free by pulling back the black cover. If it does not pull back, remove any remaining nuts or screws Caution! While working in the amp head, use only one hand to ensure safety from electrical shock. This is a rare occurrence but only using one hand will protect you. Do not "ground" yourself by touching anything else with your other hand. Do not touch any unfamiliar components. Locate the three pin connecters between the two PCBS. Gently unplug them by pulling straight up.
  • Ensure that the front panel is free by pulling back the black cover. If it does not pull back, remove any remaining nuts or screws

  • Caution! While working in the amp head, use only one hand to ensure safety from electrical shock. This is a rare occurrence but only using one hand will protect you. Do not "ground" yourself by touching anything else with your other hand. Do not touch any unfamiliar components.

  • Locate the three pin connecters between the two PCBS. Gently unplug them by pulling straight up.

  • Remove the PCB from the amp head and set it aside to get ready for soldering

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります