メインコンテンツにスキップ

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての17個のガイドに反映されます。

英語
日本語

手順 15を翻訳中

手順15
Make sure the battery is disconnected before you disconnect or reconnect the cables in this step. Use a plastic opening tool or a fingernail to disconnect the LCD cable connector. The LCD and Digitizer connectors are on the same cable assembly, so prying the LCD connector up should disconnect both connectors. Double check that the two cables are fully disconnected before removing the display.
  • Make sure the battery is disconnected before you disconnect or reconnect the cables in this step.

  • Use a plastic opening tool or a fingernail to disconnect the LCD cable connector.

  • The LCD and Digitizer connectors are on the same cable assembly, so prying the LCD connector up should disconnect both connectors. Double check that the two cables are fully disconnected before removing the display.

  • When reassembling your phone, the LCD cable may pop off its connector. A blank screen, or white lines on the display could be caused by a loose connection. Should this happen, reconnect the cable and power cycle your phone. The best way to power cycle your phone is to disconnect and reconnect the battery.

フロントパネルを手で固定しながら、LCDケーブルコネクターを外します。

LCDとデジタイザーコネクターは同じケーブルアセンブリに繋がっています。そのため、LCDコネクターの接続を外すと双方のコネクターが外れてしまいます。ディスプレイを取り出す前に、2つのケーブルの接続が完全に切ってあるか確認してください。

デバイスを再組み立てする際に、LCDケーブルがコネクターから外れてしまうことがあります。これは電話の電源を入れた時、黒い画面に白い線が入る状態の原因となります。この症状が現れる場合は単純にケーブルをコネクターに再接続をして、電話を再起動してください。電話の再起動はバッテリーを一度外して、再度取り付けます。

[* icon_caution] Make sure the battery is disconnected before you disconnect or reconnect the cables in this step.
[*
black] Use a plastic opening tool or a fingernail to disconnect the LCD cable connector.
[* icon_caution] Make sure the battery is disconnected before you disconnect or reconnect the cables in this step.
[*
black] Use a plastic opening tool or a fingernail to disconnect the LCD cable connector.
[* icon_caution] The LCD and Digitizer connectors are on the same cable assembly, so prying the LCD connector up should disconnect both connectors. Double check that the two cables are fully disconnected before removing the display.
[* icon_reminder] When reassembling your phone, the LCD cable may pop off its connector. A blank screen, or white lines on the display could be caused by a loose connection. Should this happen, reconnect the cable and power cycle your phone. The best way to power cycle your phone is to disconnect and reconnect the battery.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります