注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての17個のガイドに反映されます。
手順 12を翻訳中
手順12
-
Remove the following Phillips #000 screws securing the front panel assembly cable bracket to the logic board:
-
Two 1.3 mm screws
-
One 1.7 mm screw
-
One 3.25 mm screw
[* black] Remove the following Phillips #000 screws securing the front panel assembly cable bracket to the logic board: |
[* red] Two 1.3 mm screws |
[* orange] One 1.7 mm screw |
[* yellow] One 3.25 mm screw |
[* icon_caution] It is especially important to keep track of your screws in this step for reassembly. Accidentally using the 3.25 mm screw or the 1.7 mm screw in the bottom right hole will result in significant damage to the logic board causing the phone to no longer boot properly. |
[* icon_caution] Be careful not to over-tighten the screws. If they don't fit easily when you are securing them, they may be the wrong |
[* icon_caution] Be careful not to over-tighten the screws. If they don't fit easily when you are securing them, they may be the wrong |
クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。