Skip to main content
英語
日本語

手順 15を翻訳中

手順15
If you do not have Helping Hands on hand, be careful not to touch the tip of your soldering iron. It may help to hold the board at an angle in this scenario. While it may be possible to do a partial capacitor replacement, the remaining capacitors will also fail. It's best to do all of them at once. If you do not know how to solder, refer to this guide: はんだ付けとはんだ除去の作業ガイド. Move in a workspace with ventilation or use a fume extractor. Once in an appropriate workspace, desolder the old capacitors. Heat one leg up and remove the capacitor. Do this for both legs.
Remove the old capacitors
  • If you do not have Helping Hands on hand, be careful not to touch the tip of your soldering iron. It may help to hold the board at an angle in this scenario.

  • While it may be possible to do a partial capacitor replacement, the remaining capacitors will also fail. It's best to do all of them at once. If you do not know how to solder, refer to this guide: はんだ付けとはんだ除去の作業ガイド.

  • Move in a workspace with ventilation or use a fume extractor. Once in an appropriate workspace, desolder the old capacitors. Heat one leg up and remove the capacitor. Do this for both legs.

  • After removing the capacitors, clean up the old solder. To do this, take a desoldering braid and clean up the solder from the pads. The desoldering braid must be lifted up with your soldering iron.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります