Skip to main content

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての28個のガイドに反映されます。

英語
中国語

手順 2を翻訳中

Step 2
The lower case is constructed of rubber-coated aluminum. Do not excessively bend the aluminum during removal, as any permanent deformation will cause tolerance issues after reassembly. Slightly lift the lower case near the vent opening. Continue running your fingers between the lower and upper cases until the upper case pops off its retaining clips.
  • The lower case is constructed of rubber-coated aluminum. Do not excessively bend the aluminum during removal, as any permanent deformation will cause tolerance issues after reassembly.

  • Slightly lift the lower case near the vent opening.

  • Continue running your fingers between the lower and upper cases until the upper case pops off its retaining clips.

  • The location of these three clips is shown in the third picture.

下壳由橡胶涂层的铝构成。 在拆卸过程中不要过度弯曲铝壳,因为任何永久变形会导致重新组装后的公差问题。

从散热口附近处稍微提起。

继续在下方和上方之间使用你的手指,直到顶壳从卡扣中弹出。

这三个的位置显示在第三张图片中。

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります