メインコンテンツにスキップ

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての16個のガイドに反映されます。

英語
中国語

手順 18を翻訳中

手順18
With both plastic cards inserted as shown near the corners, gently twist the cards sideways to increase the gap between display and case. If there are any sections that seem to stick and won't separate, stop twisting and use one of the cards to cut the remaining adhesive. Begin to lift the top of the display up from the frame.
  • With both plastic cards inserted as shown near the corners, gently twist the cards sideways to increase the gap between display and case.

  • If there are any sections that seem to stick and won't separate, stop twisting and use one of the cards to cut the remaining adhesive.

  • Begin to lift the top of the display up from the frame.

  • Only lift the display a few inches—the display data and power cables are still connected to the logic board.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります