メインコンテンツにスキップ

修理を始めるには

修理する権利

パーツ&ツール

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての9個のガイドに反映されます。

英語
ドイツ語

手順 1を翻訳中

手順1
Remove the four 7.5 mm T8 screws from behind the GPU on the logic board. These screws are set inside large, spring-loaded Phillips #2 screws. To prevent the larger screws from spinning when you loosen the T8 screws, hold them with a fingertip or Phillips #2 screwdriver. These screws are set inside large, spring-loaded Phillips #2 screws. To prevent the larger screws from spinning when you loosen the T8 screws, hold them with a fingertip or Phillips #2 screwdriver.
  • Remove the four 7.5 mm T8 screws from behind the GPU on the logic board.

  • These screws are set inside large, spring-loaded Phillips #2 screws. To prevent the larger screws from spinning when you loosen the T8 screws, hold them with a fingertip or Phillips #2 screwdriver.

Entferne die vier 7,5 mm T9 Schrauben hinter der GPU auf dem Logic Board.

Diese Schrauben befinden sich in langen, durch eine Feder unter Spannung stehenden Kreuzschlitzschrauben #2. Damit diese sich nicht drehen, wenn du die Torx Schrauben löst, musst du sie mit der Fingerspitze oder einem Kreuzschlitzschraubendreher #2 festhalten.

[* red] Remove the four 7.5 mm T9T8 screws from behind the GPU on the logic board.
[* icon_note] These screws are set inside large, spring-loaded Phillips #2 screws. To prevent the larger screws from spinning when you loosen the T9T8 screws, hold them with a fingertip or Phillips #2 screwdriver.
[* red] Remove the four 7.5 mm T9T8 screws from behind the GPU on the logic board.
[* icon_note] These screws are set inside large, spring-loaded Phillips #2 screws. To prevent the larger screws from spinning when you loosen the T9T8 screws, hold them with a fingertip or Phillips #2 screwdriver.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります