メインコンテンツにスキップ

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての34個のガイドに反映されます。

英語
中国語

手順 2を翻訳中

手順2
Unplug the left speaker cable by pulling it straight up out of its socket on the logic board. De-route the cable from the gap between the hard drive and logic board. If the gap between the hard drive and logic board is too narrow for the speaker cable, disconnect it and leave the cable in place.
  • Unplug the left speaker cable by pulling it straight up out of its socket on the logic board.

  • De-route the cable from the gap between the hard drive and logic board.

  • If the gap between the hard drive and logic board is too narrow for the speaker cable, disconnect it and leave the cable in place.

将左侧扬声器的电缆从逻辑板上的插座中拔出。 确保已经将其从插座中拔出。

将电缆从硬盘与逻辑板之间的缝隙中取出。

如果硬盘与逻辑板之间的缝隙过于狭窄,就将电缆与逻辑板断开后将线缆先暂时放在合适位置。

-[* black] Unplug the left speaker cable from its socket on the logic board. Be sure to pull straight up out of the socket.
+[* black] Unplug the left speaker cable by pulling it straight up out of its socket on the logic board.
[* black] De-route the cable from the gap between the hard drive and logic board.
[* icon_note] If the gap between the hard drive and logic board is too narrow for the speaker cable, disconnect it and leave the cable in place.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります