メインコンテンツにスキップ

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての43個のガイドに反映されます。

英語
イタリア語

手順 3を翻訳中

手順3
Use the tool like a pizza cutter—roll it along through the gap, and it will cut the foam adhesive through the center. Be sure to always push with the handle behind the cutting wheel. If you pull, the wheel might get pulled out of the handle. Run the tool up along the left side of the display.
  • Use the tool like a pizza cutter—roll it along through the gap, and it will cut the foam adhesive through the center.

  • Be sure to always push with the handle behind the cutting wheel. If you pull, the wheel might get pulled out of the handle.

  • Run the tool up along the left side of the display.

Usa l'attrezzo come una rotella tagliapizza - fallo girare nella fessura per taglierà la parte centrale dell'adesivo in schiuma.

Assicurati di spingere l'impugnatura dietro la rotella. Se tirassi, la rotella potrebbe uscire dal manico.

Fai scorrere l'attrezzo lungo la parte sinistra del display.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります