メインコンテンツにスキップ

修理を始めるには

修理する権利

パーツ&ツール

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての2個のガイドに反映されます。

英語
フランス語

手順 11を翻訳中

手順11
Repeat the previous step for the 15 adhesive strip, placing it along the left half of the bottom of edge of the iMac. Once you've applied all the adhesive strips, the iMac should look as shown in the photo.
  • Repeat the previous step for the 15 adhesive strip, placing it along the left half of the bottom of edge of the iMac.

  • Once you've applied all the adhesive strips, the iMac should look as shown in the photo.

Avec la protection frontale toujours en place, alignez la bande 14 avec le bord inférieur droit de l'arrière de l'écran.

Le coin en forme de "L" à la fin de de la bande adhésive doit correspondre à l'arrière de l'écran LCD.

[* black] WithRepeat the front-side backing still on, line strip 14 up withprevious step for the 15 adhesive strip, placing it along the left half of the bottom rightof edge of the rear of the displayiMac.
[* black] The "L" shaped corner aticon_note] Once you've applied all the end ofadhesive strips, the stripiMac should fit around the back oflook as shown in the LCDphoto.
[* black] WithRepeat the front-side backing still on, line strip 14 up withprevious step for the 15 adhesive strip, placing it along the left half of the bottom rightof edge of the rear of the displayiMac.
[* black] The "L" shaped corner aticon_note] Once you've applied all the end ofadhesive strips, the stripiMac should fit around the back oflook as shown in the LCDphoto.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります