手順番号2–iHome iH8BR Motherboard Assembly Replacementを翻訳 - iFixit

キャンセル

注意：あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての5個のガイドに反映されます。

ガイドに戻る

英語

日本語

前の手順次の手順

手順 2を翻訳中

手順2

Turn the iHome 180 degrees and carefully pull up on speaker cases to pry them loose from the bottom case.

Prying the Motherboard Assembly from the Upper Case will require a good amount of force. Be very careful not to break the case, or yank on any of the ribbon wires attached to the underside.

Turn the iHome 180 degrees and carefully pull up on speaker cases to pry them loose from the bottom case.
Prying the Motherboard Assembly from the Upper Case will require a good amount of force. Be very careful not to break the case, or yank on any of the ribbon wires attached to the underside.
- Pulling outwards on the sides of the Upper Casing can help loosen the assembly.
- If it seems too difficult to remove, chances are that a screw is still attached. Make sure you've removed every screw listed before proceeding to this step.
Pull the back adapter cover off.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。