メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

英語
日本語

手順 1を翻訳中

手順1
One by one, de-solder the line of nine wires attached to the docking port board. After pulling out the wires, save them. This is done so that you can solder them into the new docking port board.
  • One by one, de-solder the line of nine wires attached to the docking port board. After pulling out the wires, save them. This is done so that you can solder them into the new docking port board.

  • If you don't know how to solder, check out はんだ付けとはんだ除去の作業ガイド.

  • Soldering irons are extremely hot and can burn you if you touch them!

  • If you hold the soldering iron tip at the same spot for too long, it can strip the metal from the plastic board. You may not be able to solder wire to that point again.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります