メインコンテンツにスキップ
英語
日本語

手順 14を翻訳中

手順14
Hold the phone so that the right edge is facing upward. Apply a few drops of high-concentration (90% or higher) isopropyl alcohol in the gap between the right edge of the screen and the frame to weaken the inner adhesive near the fingerprint sensor.
Loosen the inner adhesive
  • Hold the phone so that the right edge is facing upward.

  • Apply a few drops of high-concentration (90% or higher) isopropyl alcohol in the gap between the right edge of the screen and the frame to weaken the inner adhesive near the fingerprint sensor.

  • Insert the isopropyl alcohol applicator near the top of the inner adhesive area to avoid damaging the fingerprint sensor.

  • You may apply the isopropyl alcohol without inserting the applicator into the phone if needed.

  • Tilt the phone so that the isopropyl alcohol flows toward the inner adhesive.

  • Wait two minutes for the alcohol to weaken the adhesive.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります