メインコンテンツにスキップ
英語
中国語

手順 1を翻訳中

手順1
Using a Phillips #2 screwdriver, remove the two screws (circled in red) attaching the fan assembly to the unit. Carefully disconnect the fan connector from the socket, as depicted in the second picture.
  • Using a Phillips #2 screwdriver, remove the two screws (circled in red) attaching the fan assembly to the unit.

  • Carefully disconnect the fan connector from the socket, as depicted in the second picture.

  • The controller connector panel can be gently pulled out of the main unit and laid down, as depicted. This is not strictly required, but may provide more maneuverability inside the case.

  • Make sure to not pull out the wires while removing the fan. Doing so may damage the connector wire or the PCB.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります