メインコンテンツにスキップ
英語
日本語

手順 2を翻訳中

手順2
One side at a time, insert a pick next to the nosepiece, slide it to the edge and pry. When both sides are loose, carefully lift the cover out.
Remove the rear cover
  • One side at a time, insert a pick next to the nosepiece, slide it to the edge and pry.

  • When both sides are loose, carefully lift the cover out.

  • The proximity sensor is still connected, so be careful to not rip the flex cable.

  • Unlatch the small black clip and pull the flex cable out. It is lightly adhered to the headset.

  • During reassembly, make sure to position the cable correctly. Latching the small black clip back on shouldn't require much force. If you don't connect the cable correctly, the headset's screen may stay black and the device will turn off after a few seconds.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります