メインコンテンツにスキップ
英語
フランス語

手順 13を翻訳中

手順13
Use a Phillips screwdriver to remove the 8.5 mm-long screw securing the controller board to the hard drive. Slide the controller board straight off the end of the hard drive to remove it. There will be a bit of resistance when removing this board, since it's connected to the hard drive's SATA and power connectors.
Remove the controller board
  • Use a Phillips screwdriver to remove the 8.5 mm-long screw securing the controller board to the hard drive.

  • Slide the controller board straight off the end of the hard drive to remove it.

  • There will be a bit of resistance when removing this board, since it's connected to the hard drive's SATA and power connectors.

Reprenez un tournevis cruciforme pour dévisser la vis de 8,5 mm de long qui attache le circuit imprimé au disque dur.

Faites glisser le circuit imprimé à l'horizontale pour l'enlever du disque dur.

Vous sentirez un peu de résistance, car le circuit est connecté aux connecteurs d'alimentation et SATA du disque dur.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります