メインコンテンツにスキップ

ご注意:あなたは前提となるガイドを編集しています。あなたが行なう変更は、この手順を含むガイド全体に反映されます。

英語
イタリア語

手順 11を翻訳中

手順11
Remove the two outer 6 mm Torx screws securing each side of the display bracket to the upper case (4 screws total). When re-assembling, back out the inner 6 mm Torx screws about a quarter turn and gently align the display and upper case before inserting the outer 6 mm Torx screws. After the display and case are aligned, tighten the inner 6 mm Torx screws, then insert and tighten the outer 6 mm Torx screws.
  • Remove the two outer 6 mm Torx screws securing each side of the display bracket to the upper case (4 screws total).

  • When re-assembling, back out the inner 6 mm Torx screws about a quarter turn and gently align the display and upper case before inserting the outer 6 mm Torx screws. After the display and case are aligned, tighten the inner 6 mm Torx screws, then insert and tighten the outer 6 mm Torx screws.

Svita le due viti Torx T8 esterne da 6 mm che fissano entrambi i lati dello schermo al case superiore (4 viti in totale).

Durante il rimontaggio, svita di un quarto di giro la vite interna Torx da 6 mm e allinea delicatamente lo schermo e il case superiore prima di avvitare le viti Torx esterne da 6 mm. Dopo aver allineato lo schermo e il case, stringi le viti Torx interne da 6 mm, quindi avvita e stringi le viti Torx esterne da 6 mm.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります