Skip to main content

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての7個のガイドに反映されます。

英語
日本語

手順 4を翻訳中

手順4
The screen is now connected only by a small cable that runs to the rear board of the camera. Using tweezers, slowly pull the cable out of the connector. For best results, grip the cable as close to the connector as possible. The screen should now be separate from the camera body. Be careful not to harm the connectors on the lens so it will reconnect successfully.
  • The screen is now connected only by a small cable that runs to the rear board of the camera. Using tweezers, slowly pull the cable out of the connector.

  • For best results, grip the cable as close to the connector as possible.

  • The screen should now be separate from the camera body. Be careful not to harm the connectors on the lens so it will reconnect successfully.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります