メインコンテンツにスキップ

ご注意:あなたは前提となるガイドを編集しています。あなたが行なう変更は、この手順を含むガイド全体に反映されます。

英語
中国語

手順 3を翻訳中

手順3
Lift the door, and keep an eye on the cables that connect to the NUC's motherboard. These cables are the power and data cables for the 2.5" hard drive bay. Carefully unplug the cables from the motherboard, and set the bracket aside. In the last photo, the slot for a blade SSD is marked with a red arrow. This is where you would install the blade SSD, and use a screw to hold it in place.
Lid and HDD Bracket
  • Lift the door, and keep an eye on the cables that connect to the NUC's motherboard. These cables are the power and data cables for the 2.5" hard drive bay.

  • Carefully unplug the cables from the motherboard, and set the bracket aside.

  • In the last photo, the slot for a blade SSD is marked with a red arrow. This is where you would install the blade SSD, and use a screw to hold it in place.

抬起盖子,注意连接在NUC主板上的线缆。这1些线是2.5寸硬盘的电源和数据线.

小心地从主板上拔下线缆,把硬盘架放在一边。

在最后一张照片中,刀片SSD的槽用红色箭头标出。这是安装刀片SSD的地方,用螺丝固定。

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります