注意:あなたはさきほど閲覧しているガイドの前提となるページを編集しています。あなたが行った変更は、この手順を含むガイド全体に影響を与えます。
-
Disconnect the trackpad and keyboard ribbon cable from the logic board, removing tape as necessary.
-
Note: It is possible to replace the hard drive without disconnecting the keyboard from the chassis, but it will need to be held upright to keep it out of the way, while still allowing you both hands to work on the drive removal.
-
Be careful when removing the keyboard-trackpad ribbon cable to ensure that the rear of the upper case is disengaged from the area near the hinge. It is easy to accidentally bend the screw receivers on either side of the keyboard.
-
Remove the upper case.
クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。
ガイド手順編集のキーボードショートカット:
Ctrl + Shift + N
下に新しい行を挿入
Ctrl + Shift + P
上に新しい行を挿入
すべてのショートカットを表示する