メインコンテンツにスキップ

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての7個のガイドに反映されます。

英語
日本語

手順 2を翻訳中

手順2
Secure a suction handle to the bottom of the back cover, as close to the edge as possible. If the phone's rear glass is cracked, the suction handle may not stick. Try lifting it with strong tape, or superglue the suction handle in place and allow it to cure so you can proceed. Lift the back cover with the suction handle to create a small gap between the cover and the frame.
  • Secure a suction handle to the bottom of the back cover, as close to the edge as possible.

  • If the phone's rear glass is cracked, the suction handle may not stick. Try lifting it with strong tape, or superglue the suction handle in place and allow it to cure so you can proceed.

  • Lift the back cover with the suction handle to create a small gap between the cover and the frame.

  • Insert an opening pick into the gap.

  • If you have trouble, apply more heat to further soften the adhesive. Follow the iOpener instructions to avoid overheating.

  • Slide the opening pick to the bottom right corner.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります