メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての9個のガイドに反映されます。

英語
フランス語

手順 3を翻訳中

手順3
Use a T5 Torx driver to remove the following screws securing the right speaker to the upper case: One black 6.8 mm screw
  • Use a T5 Torx driver to remove the following screws securing the right speaker to the upper case:

  • One black 6.8 mm screw

  • One silver 6.3 mm screw

  • One black 4.9 mm screw

  • The silver screw (in the corner) may be covered with a foam pad. If so, use your tweezers to peel it up and remove it.

Dévissez les vis suivantes, fixant le haut-parleur droit au boîtier supérieur :

Une vis Torx T5 de 6,8 mm

Deux vis Torx T5 de 6,3 mm

Il est possible que la vis dans le coin soit recouverte d'un peu d'éponge métallique. Retirez-la à l'aide d'une pincette ou de la pointe de votre spatule.

[* black] RemoveUse a T5 Torx driver to remove the following screws securing the right speaker to the upper case:
[* red] One black 6.8 mm T5 Torx screw
[* orange] TwoOne silver 6.3 mm T5 Torx screwsscrew
[* yellow] One black 4.9 mm screw

[* icon_note] The cornersilver screw (in the corner) may be covered with some metallic sponge that should be removed witha foam pad. If so, use your tweezers or the corner of your spudgerto peel it up and remove it.
[* black] RemoveUse a T5 Torx driver to remove the following screws securing the right speaker to the upper case:
[* red] One black 6.8 mm T5 Torx screw
[* orange] TwoOne silver 6.3 mm T5 Torx screwsscrew
[* yellow] One black 4.9 mm screw

[* icon_note] The cornersilver screw (in the corner) may be covered with some metallic sponge that should be removed witha foam pad. If so, use your tweezers or the corner of your spudgerto peel it up and remove it.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります