メインコンテンツにスキップ
英語
日本語

手順 5を翻訳中

手順5
Whenever working inside the machine, prevent ESD (electrostatic discharge)! Wear a conductive wrist strap and avoid insulating clothes such as wool, nylon, or synthetic material. Only place boards on a non-conductive bag or anti-static working mat. Remove the Infinite Reality frontplane by pulling it straight out. This circuit board connects the raster manager boards (up to 4) to the display generator. remove the SCSI and I/O bulkhead cables from the IO4 circuit board.
  • Whenever working inside the machine, prevent ESD (electrostatic discharge)! Wear a conductive wrist strap and avoid insulating clothes such as wool, nylon, or synthetic material. Only place boards on a non-conductive bag or anti-static working mat.

  • Remove the Infinite Reality frontplane by pulling it straight out. This circuit board connects the raster manager boards (up to 4) to the display generator.

  • remove the SCSI and I/O bulkhead cables from the IO4 circuit board.

  • Pinch the side levers together and the connector will pop out.

  • Remove the graphics bulkhead cable from the display generator circuit board.

  • Two thumbscrews hold this cable in place. If these screws are stuck, a flat screwdriver can be used.

  • Hold these cables out of the way when removing circuit boards from the cage. They are fragile and can snag easily.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります