メインコンテンツにスキップ
英語
日本語

手順 2を翻訳中

手順2
Check the safety switch wiring and connector
  • Use a small clamp to push down the safety switch that detects that the top cover has been removed. The mower will not run if this switch isn't pushed.

  • Extend the mower handle to the operating position. The mower will not run if handle isn't extended. There's a micro switch in the handle latch assembly, on the side with the cable.

  • Connect the battery box. Be sure to put the correct wires on each of the 3 terminals.

  • Insert the battery. Push down hard until it clicks.

  • Start the mower with the handle switch.

  • Locate the 3-wire cable and connector on the logic board that connects to the safety switch in the handle. (See the video) Wiggle this cable to see if the motor starts or stops.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります