メインコンテンツにスキップ
英語
日本語

手順 2を翻訳中

手順2
Before you begin, figure out how the pre-cut adhesive strip should be oriented and which surface to attach it to. If your pre-cut adhesive has pull tabs on the inner perimeter, the adhesive will attach to the phone's battery well first. If your pre-cut adhesive strip has pull tabs on the outer perimeter, the adhesive will attach to the battery first.
  • Before you begin, figure out how the pre-cut adhesive strip should be oriented and which surface to attach it to.

  • If your pre-cut adhesive has pull tabs on the inner perimeter, the adhesive will attach to the phone's battery well first.

  • If your pre-cut adhesive strip has pull tabs on the outer perimeter, the adhesive will attach to the battery first.

  • Peel the clear plastic liner off of the pre-cut adhesive strip, exposing the adhesive.

  • Line up a long edge of the adhesive with the proper surface, as determined above.

  • Set the adhesive down lightly on the surface.

  • If it is not properly aligned, you can carefully peel the adhesive back up and realign it.

作業を始める前に、プレカットされた接着剤をバッテリー の向きに合わせてください。

プレカットされた接着ストリップからプラスチックの透明ライナーを剥がして、接着面を露出させます。

接着剤の長辺側の端をバッテリーの端に合わせます。

接着剤をフレーム上に軽くのせます。

正しく揃っていない場合は、慎重に接着剤を剥がして、再調整してください。

[* black] Beforeicon_note] Before you begin, notefigure out how the pre-cut adhesive strip should be oriented inand which surface to attach it to.
[* black] If your pre-cut adhesive has pull tabs on the inner perimeter, the adhesive will attach to the phone's battery well first.
[* black] If your pre-cut adhesive strip has pull tabs on the outer perimeter, the adhesive will attach to
the battery wellfirst.
[* black] Beforeicon_note] Before you begin, notefigure out how the pre-cut adhesive strip should be oriented inand which surface to attach it to.
[* black] If your pre-cut adhesive has pull tabs on the inner perimeter, the adhesive will attach to the phone's battery well first.
[* black] If your pre-cut adhesive strip has pull tabs on the outer perimeter, the adhesive will attach to
the battery wellfirst.
[* black] Peel the '''clear plastic liner''' off of the pre-cut adhesive strip, exposing the adhesive.
[* black] Line up a long edge of the adhesive with the edge of the battery wellproper surface, as determined above.
[* black] Set the adhesive down lightly on the framesurface.
[* black] Line up a long edge of the adhesive with the edge of the battery wellproper surface, as determined above.
[* black] Set the adhesive down lightly on the framesurface.
[* black] If it is not properly aligned, you can carefully peel the adhesive back up and realign it.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります