メインコンテンツにスキップ
英語
スペイン語

手順 2を翻訳中

手順2
Before you begin, figure out how the pre-cut adhesive strip should be oriented and which surface to attach it to. If your pre-cut adhesive has pull tabs facing the center hole, the adhesive will attach to the phone's battery well first. If your pre-cut adhesive strip has pull tabs on the outer perimeter, the adhesive will attach to the battery first.
  • Before you begin, figure out how the pre-cut adhesive strip should be oriented and which surface to attach it to.

  • If your pre-cut adhesive has pull tabs facing the center hole, the adhesive will attach to the phone's battery well first.

  • If your pre-cut adhesive strip has pull tabs on the outer perimeter, the adhesive will attach to the battery first.

  • Peel the clear plastic liner off of the pre-cut adhesive strip, exposing the adhesive.

  • Line up a long edge of the adhesive with the proper surface, as determined above.

  • Carefully set the adhesive down on the surface.

  • The adhesive is very sticky, so you have only one chance to align it.

Antes de iniciar, averiguar cómo debe ser orientado el adhesivo pre-cortado y a que superficie debe ser fijado.

Si el adhesivo pre-cortado tiene las pestañas para separar el plástico protector apuntando al orificio central, el adhesivo debe ser bien fijado primero al teléfono en el área destinada a la batería.

Si el adhesivo pre-cortado tiene las pestañas para separar el plástico protector en el perímetro exterior, el adhesivo debe fijarse primero a la batería.

Retira el revestimiento de plástico transparente de la tira adhesiva pre-cortada, exponiendo el adhesivo.

Alinea un borde largo del adhesivo con el borde de la cavidad de la batería.

Coloca el adhesivo ligeramente sobre la superficie.

Si el adhesivo no está adecuadamente alineado, puede ser despegado nuevamente con sumo cuidado y realinear

[* icon_note] Before you begin, figure out how the pre-cut adhesive strip should be oriented and which surface to attach it to.
[* black] If your pre-cut adhesive has pull tabs facing the center hole, the adhesive will attach to the phone's battery well first.
[* black] If your pre-cut adhesive strip has pull tabs on the outer perimeter, the adhesive will attach to the battery first.
[* black] Peel the ***clear plastic liner*** off of the pre-cut adhesive strip, exposing the adhesive.
[* black] Line up a long edge of the adhesive with the proper surface, as determined above.
-[* black] Set the adhesive down lightly on the surface.
- [* black] If it is not properly aligned, you can carefully peel the adhesive back up and realign it.
+[* black] Carefully set the adhesive down on the surface.
+ [* icon_note] The adhesive is very sticky, so you have only one chance to align it.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります