メインコンテンツにスキップ

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての8個のガイドに反映されます。

英語
イタリア語

手順 5を翻訳中

手順5
Slide the opening tool back and forth across the bottom edge of the phone, cutting through the adhesive securing the rear glass panel. Once the adhesive is cut and the gap is wide enough, insert an opening pick into the gap to keep the adhesive from re-bonding. Remove the opening tool. Once the adhesive is cut and the gap is wide enough, insert an opening pick into the gap to keep the adhesive from re-bonding. Remove the opening tool.
  • Slide the opening tool back and forth across the bottom edge of the phone, cutting through the adhesive securing the rear glass panel.

  • Once the adhesive is cut and the gap is wide enough, insert an opening pick into the gap to keep the adhesive from re-bonding. Remove the opening tool.

Fai scorrere lo strumento di apertura avanti e indietro lungo il bordo inferiore del telefono per tagliare l'adesivo che fissa il pannello di vetro posteriore.

Una volta che l'adesivo è tagliato e la fessura si è allargata abbastanza, inserisci un plettro di apertura nella fessura per impedire che la colla possa riattaccarsi. Rimuovi lo strumento di apertura.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります