メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての8個のガイドに反映されます。

英語
日本語

手順 1を翻訳中

手順1
In the following steps you'll be cutting through the adhesive that adheres the rear glass panel to the phone. For reference, the backside of the panel is shown in the first photo. Note the clearance between the edge of the panel and the fragile ribbon cable beside the fingerprint sensor. Be careful as you slice and pry to the left side of the fingerprint sensor, as seen from the outside of the phone in the third photo.
  • In the following steps you'll be cutting through the adhesive that adheres the rear glass panel to the phone.

  • For reference, the backside of the panel is shown in the first photo. Note the clearance between the edge of the panel and the fragile ribbon cable beside the fingerprint sensor.

  • Be careful as you slice and pry to the left side of the fingerprint sensor, as seen from the outside of the phone in the third photo.

  • Inserting an opening tool more than 3 mm into the phone in this area can damage or tear the fingerprint sensor cable.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります