メインコンテンツにスキップ

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての7個のガイドに反映されます。

英語
中国語

手順 7を翻訳中

手順7
Once you have sliced around the phone, twist an opening pick in one of the edges to help separate the back cover from the frame. Lift the back cover slowly. Use opening picks to slice any remaining adhesive. Remove the back cover.
  • Once you have sliced around the phone, twist an opening pick in one of the edges to help separate the back cover from the frame.

  • Lift the back cover slowly. Use opening picks to slice any remaining adhesive.

  • Remove the back cover.

  • During reassembly, this is a good point to power on your phone and test all functions before you seal the back cover in place. Be sure to power your phone back down completely before you continue working.

  • Follow this guide to reinstall the back cover, transfer and install the camera bezel, and replace the adhesive.

在手机上划开之后,扭动其中一个边缘的三角撬片,以帮助将后盖与框架分开。

慢慢抬起后盖。使用三角撬片切割任何剩余的粘合剂。

取下后盖。

在重新安装后盖之前,务必清除框架上的所有粘合剂残留物。在重新组装过程中,在将后盖密封到位之前,这是打开手机电源并测试所有功能的号时机。在继续工作之前,请务必将手机完全重新打开。

请按照本指南重新安装后盖,转移并安装相机挡板,并更换粘合剂。

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります