メインコンテンツにスキップ

Sostituzione gruppo LCD iPad Mini CDMA

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての42個のガイドに反映されます。

手順 11を翻訳中

英語
イタリア語
手順11
iPad Mini CDMA LCD Assembly Replacement: 手順 0、 3の画像 1 iPad Mini CDMA LCD Assembly Replacement: 手順 0、 3の画像 2 iPad Mini CDMA LCD Assembly Replacement: 手順 0、 3の画像 3
  • Starting at the top right of the device, slide the spudger in between the LCD frame and metal backing plate, which will separate the adhesive as you push.

  • The goal is to separate the adhesive, not to pry the LCD up, so keep the pointed tip of the spudger as low as possible to prevent bending the LCD.

  • If inserting the spudger causes the corner of the LCD to bend up, repeat the steps with the guitar pick to further loosen the adhesive.

Iniziando nell'angolo in alto a destra del pannello, fai scorrere lo spudger tra la cornice del pannello LCD e la sua protezione in metallo, il che separerà l'adesivo man mano che avanzi.

L'obiettivo è separare l'adesivo, non di sollevare il pannello LCD, quindi tieni la punta dello spudger il più in basso possibile per evitare di piegare il pannello.

Se infilare lo spudger causa una piega nell'angolo del pannello, ripeti i passaggi precedenti con il plettro per ammorbidire ulteriormente l'adesivo.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります