メインコンテンツにスキップ

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての3個のガイドに反映されます。

英語
スペイン語

手順 5を翻訳中

手順5
Lift the home button bracket starting from the left side. Carefully pull it upwards toward the display, making sure not to damage the home button cable. During reassembly, after installing the home button, you'll need to glue this bracket into place to secure it.
  • Lift the home button bracket starting from the left side.

  • Carefully pull it upwards toward the display, making sure not to damage the home button cable.

  • During reassembly, after installing the home button, you'll need to glue this bracket into place to secure it.

  • Scrape off as much of the old adhesive residue as you can, then clean it with acetone or high-concentration (90% or greater) isopropyl alcohol.

  • Secure the bracket with a high bond glue, superglue, or high-strength double-sided tape. Make sure the bracket is aligned correctly before allowing your adhesive to cure, or the home button will not click when pressed.

  • It may be necessary to use vise clamps to hold the home button bracket in place as the adhesive cures.

Levanta el soporte del botón de inicio comenzando por el lado izquierdo.

Tira con cuidado de él hacia la pantalla, asegurándose de no dañar el cable del botón de inicio.

Durante el reensamblaje, después de instalar el botón de inicio, deberás pegar este soporte en su lugar para asegurarlo.

Quita la mayor cantidad posible de residuos de adhesivo viejo y luego límpielo con acetona o alcohol isopropílico de alta concentración (90% o más).

Asegura el soporte con pegamento instantáneo termofusible o cinta adhesiva de doble cara de alta resistencia. Asegúrese de que el soporte esté alineado correctamente antes de permitir que el adhesivo se cure, o el botón de inicio no hará clic cuando se presione.

[* black] Lift the home button bracket starting from the left side.
[* black] Carefully pull it upwards toward the display, making sure not to damage the home button cable.
[* icon_reminder] During reassembly, after installing the home button, you'll need to glue this bracket into place to secure it.
[* black] Scrape off as much of the old adhesive residue as you can, then clean it with acetone or high-concentration (90% or greater) isopropyl alcohol.
- [* black] Secure the bracket with hot-melt glue, superglue, or [product|IF317-072|high-strength double-sided tape]. Make sure the bracket is aligned correctly before allowing your adhesive to cure, or the home button will not click when pressed.
+ [* black] Secure the bracket with a [product|IF145-413|high bond glue|new_window=true], superglue, or [product|IF317-072|high-strength double-sided tape]. Make sure the bracket is aligned correctly before allowing your adhesive to cure, or the home button will not click when pressed.
+ [* icon_note] It may be necessary to use [guide|142291|vise clamps|new_window=true] to hold the home button bracket in place as the adhesive cures.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります