メインコンテンツにスキップ
フランス語
英語

Mac Pro 2009-2012 Case Replacement

ガイド情報

= 完了 = 不完全

      現在取り組み中のこの deviceの特定のパーツやコンポーネントの詳細を記載してください。 例: バッテリー

      タイトルを作成

      この短い1−2文の概要は検索結果に表示されます。

      ガイドの編集に取りかかる前に参考資料に目を通してください。

      ガイドの手順

      手順1 — Open the Case

      To open the Mac Pro, you'll have to lift the clip on the back of the case

      手順2 — Lift the lateral flap

      Having the flap in the high position, the panel should separate from the box without force

      手順3 — Remove the hard drives

      You then have to remove the hard drives. It is simple: pull them towards you with a bit of force.

      手順4 — Remove the DVD drives

      Very simple, pull the DVD drives towards you, it should come out with a little force.

      手順5 — Remove the board

      Press both latches to unlock the bracket

      手順6 — Disconnect the GPU

      Remove the 6 pins or 8 pins connector from your graphics card

      手順7 — Disconnect the GPU power supply ( Optional )

      On the power support there is a button, press it and you can move the power supply to the left (see picture)

      手順8 — Disconnect GPU support ( optional)

      Disconnect the PCI-e cables from the motherboard

      手順9 — Take out the PCI-e fan

      With a screwdriver unscrew the two screws that hold the fan bracket to the board

      手順10 — Disconnect the SATA Cables

      Behind the fan bracket there are 2 SATA cables, a 4 pin mini power supply and a 4 pin fan

      手順11 — Unscrew CPU support

      With a H3.0 screwdriver, unscrew the screws on the bottom of the bracket (photo 2)

      手順12 — Remove the CPU Fan

      Remove the clip at the top of the fan

      手順13 — Remove the CPU Fan

      Similar to the top remove the clip at the bottom and pull out the fan.

      手順14 — Disconnect Fan and Speakers

      Disconnect the 2 x 4pin fan cables and the 1 x 2 pin speaker cable

      手順15 — Remove the CPU Support

      Pull the CPU support towards you

      手順16 — Remove the expansion card connector

      Remove the ribbon that connects the motherboard to the expansion card (USB, Jack, Power Off etc.)

      手順17 — Remove the expansion card

      Unscrew the 6 screws that hold the card in place.

      手順18 — Remove the cover

      unscrew the two screws and remove the cover

      手順19 — Unplug the power supply

      Push on both knobs to remove the power connector

      手順20 — Separate the power supply

      Unscrew the 4 screws that hold in the power supply

      手順21 — Remove the power supply

      Pull the power supply towards you.

      手順22 — Detach the bluetooth antenna

      Unclip the bluetooth antenna

      手順23 — Remove the mother board

      Unscrew the 10 screws holding in the motherboard

      手順24 — Change the case

      Follow the steps in reverse to resemble.

      クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります