メインコンテンツにスキップ

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての21個のガイドに反映されます。

英語
イタリア語

手順 14を翻訳中

手順14
Use a spudger to disconnect the two visible display flex connectors by gently prying them straight up from their sockets. To re-attach press connectors like this one, carefully align and press down on one side until it clicks into place, then repeat on the other side. Do not press down on the middle. If the connector is misaligned, the pins can bend, causing permanent damage. To re-attach press connectors like this one, carefully align and press down on one side until it clicks into place, then repeat on the other side. Do not press down on the middle. If the connector is misaligned, the pins can bend, causing permanent damage.
  • Use a spudger to disconnect the two visible display flex connectors by gently prying them straight up from their sockets.

  • To re-attach press connectors like this one, carefully align and press down on one side until it clicks into place, then repeat on the other side. Do not press down on the middle. If the connector is misaligned, the pins can bend, causing permanent damage.

Usa uno spudger per scollegare i due connettori visibili facendo leva delicatamente e sollevandoli dalle loro prese.

Per ricollegare i connettori a pressione come questo, allinea attentamente e premi su un lato finché non scatta al suo posto, quindi ripeti per l'altro lato. Non premere nel centro. Se il connettore non è allineato correttamente, i contatti si possono piegare, causando danni permanenti.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります