メインコンテンツにスキップ

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての21個のガイドに反映されます。

英語
日本語

手順 4を翻訳中

手順4
Apply heat to the left edge of the iPad for about two minutes, or until it's slightly too hot to touch comfortably. If necessary, re-heat your iOpener for a few seconds or until it's a bit too hot to touch. Be careful not to overheat the iOpener, or it may burst. Insert a second opening pick at the bottom left corner of the iPad.
Slice through the left adhesive
  • Apply heat to the left edge of the iPad for about two minutes, or until it's slightly too hot to touch comfortably.

  • If necessary, re-heat your iOpener for a few seconds or until it's a bit too hot to touch. Be careful not to overheat the iOpener, or it may burst.

  • Insert a second opening pick at the bottom left corner of the iPad.

  • Slide the second opening pick along the left side of the display to separate the adhesive underneath.

  • Leave the opening pick inserted near the top left corner of the iPad to prevent the adhesive from re-sealing.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります