Skip to main content

注意:あなたはさきほど閲覧しているガイドの前提となるページを編集しています。あなたが行った変更は、この手順を含むガイド全体に影響を与えます。

英語
日本語

手順 5を翻訳中

Step 5
Pull up on the suction cup with firm, constant pressure to create a slight gap between the front panel and rear case. Insert an opening pick into the gap. The watertight adhesive holding the display in place is very strong; creating this initial gap takes a significant amount of force. If you're having a hard time opening a gap, apply more heat, and gently rock the screen up and down to weaken the adhesive until you create enough of a gap to insert your tool.
Lift the display slightly
  • Pull up on the suction cup with firm, constant pressure to create a slight gap between the front panel and rear case.

  • Insert an opening pick into the gap.

  • The watertight adhesive holding the display in place is very strong; creating this initial gap takes a significant amount of force. If you're having a hard time opening a gap, apply more heat, and gently rock the screen up and down to weaken the adhesive until you create enough of a gap to insert your tool.

吸盤カップをしっかりと引き上げます。リアケースとフロントパネルの間に僅かな隙間が生じるまで一定の力で引っ張ります。

隙間に開口ピックを差し込みます。

ディスプレイに留められた防水用接着剤は大変強力です。この隙間をまず作るにはかなりの力が必要です。隙間がなかなか作れない場合は、さらに熱を当てて接着剤を柔らかくしてください。温まったらツールを差し込めるだけの隙間ができるまで、ゆっくりとスクリーンを上下に揺らします。

[title] Lift the display slightly
[* black] Pull up on the suction cup with firm, constant pressure to create a slight gap between the front panel and rear case.
[* black] Insert an opening pick into the gap.
[* icon_note] The watertight adhesive holding the display in place is very strong; creating this initial gap takes a significant amount of force. If you're having a hard time opening a gap, apply more heat, and gently rock the screen up and down to weaken the adhesive until you create enough of a gap to insert your tool.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります