メインコンテンツにスキップ
英語
日本語

手順 2を翻訳中

手順2
Remove all Phillips 7.5mm, 12.5mm, and 10.5mm screws holding the circuit board to the case. Make sure the device has been powered off and disconnected from the power source for at least a day before touching the electronic components.
  • Remove all Phillips 7.5mm, 12.5mm, and 10.5mm screws holding the circuit board to the case.

  • Make sure the device has been powered off and disconnected from the power source for at least a day before touching the electronic components.

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります