Skip to main content
英語
日本語

手順 2を翻訳中

手順2
Use a PH1 screwdriver to unscrew the two 9.0 mm screws on the circuit board that corresponds to the red power button. Remove gently. The circuit board is connected by wire to the console. Removing the cable from the console case may allow more slack. A spring may pop out.
  • Use a PH1 screwdriver to unscrew the two 9.0 mm screws on the circuit board that corresponds to the red power button.

  • Remove gently. The circuit board is connected by wire to the console. Removing the cable from the console case may allow more slack.

  • A spring may pop out.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります