メインコンテンツにスキップ

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての6個のガイドに反映されます。

英語
日本語

手順 1を翻訳中

手順1
Use the point of a spudger to lift and disconnect the antenna cable from the bottom end of the logic board. To reconnect antenna cables like these to the socket, carefully align the connector to the socket, then use the flat end of a spudger to press down. It should click in place. If not, check for alignment. Do not use excessive force.
  • Use the point of a spudger to lift and disconnect the antenna cable from the bottom end of the logic board.

  • To reconnect antenna cables like these to the socket, carefully align the connector to the socket, then use the flat end of a spudger to press down. It should click in place. If not, check for alignment. Do not use excessive force.

スパッジャーの先端を使って、ロジックボード先端の下側からアンテナケーブルを引き上げて、接続を外します。

[* black] Use the point of a spudger to lift and disconnect the antenna cable from the bottom end of the logic board.
[* icon_reminder] To reconnect antenna cables like these to the socket, carefully align the connector to the socket, then use the flat end of a spudger to press down. It should click in place. If not, check for alignment. Do not use excessive force.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります