Skip to main content

注意:あなたはさきほど閲覧しているガイドの前提となるページを編集しています。あなたが行った変更は、この手順を含むガイド全体に影響を与えます。

英語
日本語

手順 2を翻訳中

手順2
Always keep your fingers completely clear of the knife. Be careful not to apply too much pressure, as this might cause the knife to slip and cut you, or damage the watch. Place the edge of a curved blade into the thin gap between the display and the outer case.  Start at the short side of the display, closest to the digital crown. Insert only the thin edge of the blade into the gap, and then tilt the blade towards you to widen the gap and lift the display slightly open.
  • Always keep your fingers completely clear of the knife. Be careful not to apply too much pressure, as this might cause the knife to slip and cut you, or damage the watch.

  • Place the edge of a curved blade into the thin gap between the display and the outer case. Start at the short side of the display, closest to the digital crown.

  • Insert only the thin edge of the blade into the gap, and then tilt the blade towards you to widen the gap and lift the display slightly open.

  • Do not insert the knife more than 1/16th of an inch (~2 mm).

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります