メインコンテンツにスキップ

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての6個のガイドに反映されます。

英語
日本語

手順 2を翻訳中

手順2
Use a suction handle to lift the back cover and an opening pick to get in the gap. Since the back cover is also slightly curved at the edges you want to insert the opening pick at a lower angle from underneath. Start at the middle of the side and cut the adhesive while pulling up with the suction handle.
  • Use a suction handle to lift the back cover and an opening pick to get in the gap.

  • Since the back cover is also slightly curved at the edges you want to insert the opening pick at a lower angle from underneath.

  • Start at the middle of the side and cut the adhesive while pulling up with the suction handle.

  • Be careful not to lever the opening pick too much to avoid breaking the back cover. Rather pull with the suction handle and use the pick for cutting the adhesive.

  • Move the pick towards the bottom corner and leave it there to keep the adhesive from resealing to the case.

  • Use another pick and move it to the top corner.

  • If it's getting harder to move the pick you might need to reheat the iOpener and apply it to the back cover again.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります