メインコンテンツにスキップ

修理を始めるには

修理する権利

パーツ&ツール

英語
日本語

手順 24を翻訳中

手順24
When installing the actuator back into the door cavity, it will take a bit of trial and error to get the actuator fitting into its proper placement.
Re-installation of actuator assembly - Note
  • When installing the actuator back into the door cavity, it will take a bit of trial and error to get the actuator fitting into its proper placement.

  • As I mentioned previously, this particular assembly uses a "fork" on the inside of the door handle which slips onto a horizontal metal bar.

  • Once the actuator is in the general area that it needs to be, you'll have to start with the actuator below the door handle height and then feel for the fork and slide the actuator so that the fork slips over the bar as you bring it upwards and into position with latch metal plate torx bolt holes lined up.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります