メインコンテンツにスキップ
英語
日本語

手順 4を翻訳中

手順4
Apply solder to each of the three sets of four pins now exposed on the logic board. After each solder, apply a small amount of flux to the new connection to clean the connection. Be sure to wait at least 30 seconds after applying the flux so that it can clean and remove impurities.
  • Apply solder to each of the three sets of four pins now exposed on the logic board.

  • After each solder, apply a small amount of flux to the new connection to clean the connection.

  • Be sure to wait at least 30 seconds after applying the flux so that it can clean and remove impurities.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります