メインコンテンツにスキップ
英語
日本語

手順 1を翻訳中

手順1
Remove the following screws securing the Lightning connector assembly to the rear case:
  • Remove the following screws securing the Lightning connector assembly to the rear case:

  • One 2.9 mm Phillips screw

  • During re-installation, make sure that the headphone jack's plastic protrusion lies above the metal washer.

  • One 1.5 mm Phillips screw

  • Two 3.3 mm Phillips screws

Lightningコネクターのリボンケーブルからスピーカーアセンブリを丁寧に剥がします。

新しいパーツを使ってLightningコネクターを交換する場合、マイク周辺に巻かれているゴムケースも交換してください。スパッジャーを使うと作業がし易くなります。

-[* black] Gently peel the speaker assembly away from the Lightning connector ribbon cable.
-[* icon_note] If you are replacing the Lightning connector with a new part, make sure to transfer the rubber casing around the microphone. You can do this using a spudger.
+[* black] Remove the following screws securing the Lightning connector assembly to the rear case:
+ [* red] One 2.9 mm Phillips screw
+ [* icon_reminder] During re-installation, make sure that the headphone jack's plastic protrusion lies above the metal washer.
+ [* orange] One 1.5 mm Phillips screw
+ [* yellow] Two 3.3 mm Phillips screws

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります