メインコンテンツにスキップ
英語
日本語

手順 2を翻訳中

手順2
Use the opening tool to pry up and disconnect the Lightning connector cable connector from its socket on the logic board. Use the opening tool to pry up and disconnect the Lightning connector cable connector from its socket on the logic board.
  • Use the opening tool to pry up and disconnect the Lightning connector cable connector from its socket on the logic board.

ヘッドホンジャックの端から接地ケーブルを丁寧に剥がして外します。

ヘッドホンコネクターと外部ケーシングの間に付けられたプラスチック製ガスケットを紛失しないようにご注意ください。ヘッドホンコネクターを並べて、このガスケットが正しく配置されているか確認しましょう。

[* black] Carefully peel offUse the opening tool to pry up and removedisconnect the groundingLightning connector cable connector from its socket on the edge of the headphone jack.
[* black] Take care not to lose the plastic gasket between the headphone connector and the outer shell. While aligning the headphone connector, make sure to align this gasket correctly
logic board.
[* black] Carefully peel offUse the opening tool to pry up and removedisconnect the groundingLightning connector cable connector from its socket on the edge of the headphone jack.
[* black] Take care not to lose the plastic gasket between the headphone connector and the outer shell. While aligning the headphone connector, make sure to align this gasket correctly
logic board.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります