メインコンテンツにスキップ

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての9個のガイドに反映されます。

英語
中国語

手順 11を翻訳中

手順11
Rotate the logic board assembly toward the battery side of the rear case. Do not attempt to completely remove the logic board assembly from the rear case, yet; there is still one cable connected to the underside of the logic board. The flash surround is adhered to the flash unit and the rear case. If it stays on the rear case remove with tweezers and mount it back on the flash unit.
  • Rotate the logic board assembly toward the battery side of the rear case.

  • Do not attempt to completely remove the logic board assembly from the rear case, yet; there is still one cable connected to the underside of the logic board.

  • The flash surround is adhered to the flash unit and the rear case. If it stays on the rear case remove with tweezers and mount it back on the flash unit.

  • Note: when reassembling your device, be sure that the lower interconnect cable is not tucked underneath the logic board.

径直将主板从后壳上抬起。

现在切勿尝试完全将主板从后壳上移走。它仍有线缆与之相连。

闪光灯环被固定在闪光灯组件和后壳上。 如果它留在后壳上,用镊子取下并将其安装在闪光灯组件上。

注意:重新组装设备时,请确保下方互连电缆未被卷在主板的下方。

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります